MB Scooters designed Race-Tour 200 badge.

Made from stainless steel, polished and supplied with 2 small alloy rivets.

Fitting is easy enough, check out the photos on how to……..

1) Mark where you want them to go

2) Drill the 2 holes at 3mm, on the back side deburr and slightly counter bore the legshield  

3) Offer the badge in place pushing in the rivets

4) Hold the badge with masking tape with the rivets fitted

5) Use a large hammer on the badge side and from the back side, with a smaller hammer gently tap the alloy rivet over

6) You can polish the alloy rivets quite easily by various methods, then clean up and stand back